We Answer the Phone 24/7! Call Us Today: 763-560-5600

Logo

Knob and Tube Replacement in Minneapolis

If you have an older home, it may still be wired using the old “knob and tube” approach. Not only is this an outdated method of wiring, it could also be dangerous. If your home is wired in the fashion, please call Randy’s Electric as soon as possible for knob and tube replacement in Minneapolis to make sure your home is up to code.

Information on Knob and Tube Wiring in Minneapolis

Knob and tube wiring was chiefly used from the 1880s until the 1930s. However, there are some homes that were wired in this fashion even into the 1950s. This method was deemed the best option since electricity usage and loads were limited because there were relatively few electric appliances at the time.

In this method, wires were soldered and spliced together – without junction boxes – inside walls. They were then wrapped with electrical tape. Porcelain knobs were nailed to wood studs and joists, and wiring was rubber and cloth and covered with #14 copper. Porcelain tubes were inserted in holes with conductors inside. As a result, knob and tube wiring never touched plaster or wood structures inside a home. When heat was produced by electrical loads or overloads it dissipated in the air space between partitions and rafters.

By looking at splices and conductors, and electrician can determine the integrity of your knob and tube wiring. If the conductors are dry or bare, or you have stiff or crumbling installation, they must be replaced immediately because they are probably caused by short-circuiting or excessive current, among other reasons.

The Importance of Replacing Knob and Tube Wiring in Minneapolis

If you have knob and tube wiring, your home could be at a substantial risk of an electrical fire. Also, your family members may be at risk of shock or electrocution. You should have your knob and tube system inspected and upgraded to today’s electrical standards.

What to Expect During Your Knob and Tube Replacement in Minneapolis

When we come to your home to remove your knob and tube wiring we will more than likely need to cut a hole in your ceiling to run new wires and take out the old. However, we will repair any holes quickly and efficiently, leaving the area in which we work looking like new.

Call Randy’s Electric to find out more about how we can make your home’s electrical system not only efficient, but also safe.


Randy's Electric shared Electrical Safety Foundation International (ESFI)'s photo. ... See MoreSee Less

26% of respondents who claimed to have tested at least one of their GFCI receptacles discovered one that was not working properly. Be sure to test your AFCIs and GFCIs: www.esfi.org/resource/5-easy-steps-to-a-safer-home-404

View on Facebook

Federal Pacific breaker panels remain in thousands of local homes since the equipment was common in new home construction from the early 1960's into the 1980's....The panels have been blamed for many local fires, and they even have been suspected to be the culprit of some some fatal ones.

If you have concerns about the panel or breakers in your home, contact us right away at 763-560-5600 for an estimate. We can go over all of the options and pricing with you. Check out our video for more information, or the Star Tribune article in the comments.
... See MoreSee Less

View on Facebook

Randy's Electric shared Electrical Safety Foundation International (ESFI)'s photo. ... See MoreSee Less

Tuesday Tip: Knowing what to do when you see a downed power line could save your life and the lives of others. Learn more: bit.ly/1NISKQ4

View on Facebook

When is it time to upgrade your electrical panel? Find out today on LIVE @ 9:05! ... See MoreSee Less

View on Facebook
Randy's Electric | Copyright © 2013